Dana 60 | Front Outer Stub Axle | GM and Dodge | 12.000 long

In stock

Price may go up based on application and whether a single or a pair.

Dana 60 | Front outer stub axle | GM and Dodge | 12.000 long

Our Dutchman Dana 60 Front outer stub axles are an excellent complement to our custom front inner axles. They are forged from the same Chromoly 4340 material. A main feature that sets the Dutchman front shafts apart from the competition is the fully machined shaft and yoke, a Dutchman exclusive! This gives a consistent finish around the U-Joint ears. No more thick and thin sections or forging imperfections that can lead to premature yoke failures.

Whatever form of off-roading you’re involved in; Desert racing, mud bogging, rock crawling, or just simple trail riding, when used with a Dutchman inner and super joint, a Dutchman 4340 front outer shaft will get you home or help win the race.

-Forged from premium aircraft quality 4340 “Chromoly” material.
-Double heat treated; Thru hardened ears and shaft with induction over the entire shaft area.
-Fully machined shaft and yoke/U-Joint ears.
-Reinforced (thicker) yoke/U-Joint ears.
-The ears are machined to accept full circle snap rings.
-Uses the 1480 series U-Joint with a 1 3/8” diameter cap.
-Accepts Spicer, Yukon, CTM, Longfield, RCV, or any aftermarket brand U-Joint.

Application and Specs:
-Dana 60 [open knuckle front ends]
-35 spline
-GM and Dodge, 12” long [Center of the U-Joint to the end of the shaft]
-Reference U-Joint part #’s: Spicer 5-332x, 5-806x, SPL55-3x, SPL55-4x, SPL55-1480XC, 5-1480SPX-WJ

Price is a single.
Actual product may appear different than the pic.
WARNING: Cancer and Reproductive Harm
Write Your Own Review
You're reviewing:Dana 60 | Front Outer Stub Axle | GM and Dodge | 12.000 long
Copyright © 2017-2024 Dutchman Motorsports, Inc. All rights reserved.